|
SV & SD Features
 |
 |
|
|
- SV-Series is designed from the SD-series with 33.5"(850mm) Z-axis travel to accommodate taller parts.
- Fully supported box ways. The X, Y & Z axis are fully supported by rigid boxed ways. The models(D.E.F) with the longer distances between the columns, utilize a total of 4 box ways on the X-axis for enhanced rigidity. The table never travels over extensions, thereby insuring the rigidity throughout the entire travel of all axes.
- The Y axis utilizes a superior design where by the lower slideway is offset a full 2.76"(70mm) forward from the upper slideway. This greatly enhances the rigidity of the headstock by bringing the center of gravity back into the upper support.
- Only a distance of 3.35"(85mm) from spindle center to Z-axis slideway.
- Two gear ranges, helical and bevel gears support the spindle transmission system for machining large cavities at low RPM.
- Extended spindle (SD-Series optional) is standard accessories (SV-Series) that applies to deep hole drilling and concave milling.
- Specially designed tool unclamp cylinder. The spindle utilizes a "state of the art" designed hydraulic cylinder. This special design totally eliminates any outside forces from being applied to the spindle bearings when releasing the tool.
- Pretensioned ballscrews with air cooled thrust bearing.
- Oil cooled X-axis ballscrew(Models 3000~ 5000).
- Dual arm ATC system.
- Coolant through spindle system option can clean chips from high speed cutting and restrain heat.
- With optional Fanuc Data Server, 64-bit RISC processor and NURBS Interpolation one can achieve Hi-Speed and Hi-Accuracy Die/Mold Machining.
|
|
